ABS

ACTUATOR AND ELECTRIC UNIT (ASSEMBLY)





Removal and Installation

REMOVAL
1. Disconnect negative battery cable.
2. Remove windshield wiper motor and linkage assembly.
3. Drain brake fluid. Refer to "Changing Brake Fluid".
4. Disconnect harness connectors from ABS actuator and electric unit (control unit).
5. Disconnect brake pipes.
6. Remove nuts and bolts for ABS actuator and electric unit (control unit) and remove from vehicle.

INSTALLATION

CAUTION: After installation of ABS actuator and electric unit (control unit), refill brake fluid. Then bleed air from system. Refer to "Bleeding Brake System".

1. Position ABS actuator and electric unit (control unit) in vehicle.
2. Install and tighten ABS actuator and electric unit (control unit) nuts and bolts.
3. Install brake pipes to ABS actuator and electric unit (control unit), then tighten flare nuts.
4. Connect ABS actuator and electric unit (control unit) harness connectors.
5. Install windshield wiper motor and linkage assembly. Refer to "INSTALLATION".
6. Reconnect battery cable.