Crash Zone Sensor

CRASH ZONE SENSOR

Removal and Installation

REMOVAL

CAUTION:
- Before servicing SRS, turn the ignition switch off, disconnect both battery cables and wait at least 3 minutes.




1. Remove front grille. Refer to "Removal and Installation".
2. Remove crash zone sensor connector.
3. Remove crash zone sensor fixing nuts.

CAUTION:
- Replace crash zone sensor if it has been dropped or sustained an impact.
- Do not attempt to disassemble crash zone sensor.

INSTALLATION
Installation should be performed in the reverse procedure of removal.

CAUTION:
- Check crash zone sensor for proper installation.
- After the work is complete, perform self-diagnosis to check that no malfunction is detected. Refer to SRS-21, "SRS Operation Check". Component Tests and General Diagnostics