Front

STABILIZER BAR

Removal and Installation
REMOVAL
1. Remove the front suspension member. Refer to "FRONT SUSPENSION MEMBER".
2. Support suspension member using suitable jack support.





3. Disconnect the connecting rod end at the stabilizer bar using power tool.
^ Prevent the stabilizer connecting rod from turning by inserting a hex wrench into the end of the ball stud, then remove nut.
4. Remove the two stabilizer bar clamps from the front suspension member using power tool.
5. Remove the front stabilizer bar.
^ Remove the two stabilizer bushings as necessary.

INSTALLATION
Installation is in the reverse order of removal.





^ When installing stabilizer, make sure that the clamps are facing in the correct direction as shown.





^ Make sure that slit in bushing is in the position as shown.
^ Lubricate the inner and outer surfaces of the bushing using a silicone lubricant.

Inspection





^ Check the stabilizer bar for deformation or cracks and replace if necessary.
^ Check the bushings for deterioration or cracks. Replace if necessary.
^ Check that the ball joint can rotate in all directions. If movement is not smooth and free, replace stabilizer bar connecting rod.