Manual Shaft

Manual Shaft
REMOVAL





1. Remove detent spring from transaxle case.





2. Drive out manual plate retaining pin using Tool.
Tool number: ST23540000 (J-25689-A)





3. Drive and pull out parking rod plate retaining pin using Tool.
Tool number: ST23540000 (J-25689-A)
4. Remove parking rod plate from manual shaft.
5. Draw out parking rod from transaxle case using suitable tool.





6. Pull out manual shaft retaining pin using suitable tool.
7. Remove manual shaft and manual plate from transaxle case.





8. Remove manual shaft oil seal using suitable tool.

CAUTION: Do not damage the transaxle case.

INSPECTION
^ Check component parts for wear or damage. Replace if necessary.

INSTALLATION





1. Install manual shaft oil seal using suitable tool.

NOTE: Apply ATF to the outer surface of new oil seal





2. Install manual shaft and manual plate.





3. Align groove of manual shaft and hole of transaxle case using Tool.
Tool number: ST25710000 (J-25689-A)
4. Install manual shaft retaining pin up to bottom of hole using Tool.
Tool number: KV32101000 (J-25689-A)





5. Install parking rod to parking rod plate.
6. Set parking rod assembly onto manual shaft and drive retaining pin using Tool.

NOTE: Both ends of the pin should protrude.





7. Drive manual plate retaining pin using Tool.
Tool number: ST23540000 (J-25689-A)

NOTE: Both ends of the pin should protrude.





8. Install detent spring. Tighten detent spring bolts to the specified torque. Refer to "Components".