3. Cruise Test

3. CRUISE TEST
^ Check all items listed in Parts 1 through 3.

With CONSULT-II





^ Using CONSULT-II, conduct a cruise test and record the result.
^ Print the result and ensure that shifts and lock-ups take place as per Shift Schedule. Refer to "Shift Schedule"

CONSULT-II Setting Procedure

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carry out CAN communication.

1. Turn ignition switch OFF.





2. Connect CONSULT-II to data link connector, which is located in left side dash panel.





3. Turn ignition switch ON.
4. Touch "START (NISSAN BASED VHCL)".





5. Touch "A/T".





6. Touch "DATA MONITOR".





7. Touch "MAIN SIGNALS" or "TCM INPUT SIGNALS".
8. See "Numerical Display", "Bar chart Display"" or "Line Graph Display".





9. Touch "SETTING" to set recording condition ("AUTO TRIG" or "MANU TRIG") and touch "BACK".
10. Touch "Start".





11. When performing cruise test, touch "RECORD".





12. After finishing cruise test part 1, touch "STOP".








13. Touch "STORE" and touch "BACK".





14. Touch "DISPLAY".
15. Touch "PRINT".
16. Check the monitor data printed out.
17. Continue cruise test part 2 and 3.

Without CONSULT-II





^ Throttle position sensor can be checked by voltage across terminals 41 (W) and 42 (B) of TCM.