RS5F51A Manual Transaxle

SIDE OIL SEAL

Removal and Installation
REMOVAL





1. Remove the drive shaft from the transaxle case. Refer to "Removal and Installation".
2. Remove the oil seal using suitable tool.

CAUTION: Be careful not to damage the transaxle case surface when removing the oil seal.

INSTALLATION





Installation is in the reverse order of removal.
^ Using Tool, drive the oil seal straight in until it protrudes from the transaxle case end equal to dimension "A" as shown.
Dimension "A": Within 0.5 mm (0.02 inch) flush with case.
Tool number: ST30720000 (J-25405)

CAUTION:
^ Before installing oil seals, apply multi-purpose grease to oil seal lips.
^ Do not reuse oil seals.
^ Check the transaxle oil level after installation. Refer to "Checking".