Input Shaft End Play

INPUT SHAFT END PLAY





^ When adjusting input shaft end play, select adjusting shim for input shaft bearing. To select adjusting shim, measure clearance between transaxle case and input shaft rear bearing.
^ Calculate dimension "O" (thickness of adjusting shim) using the procedure to satisfy specification of end play for input shaft rear bearing.
End play: 0 - 0.06 mm (0 - 0.0024 inch)
Dimension
"O" = ("O1" - "O2") - End play
"O": Thickness of adjusting shim
"O1 ": Distance between transaxle case end face and mounting face of adjusting shim
"O2": Distance between clutch housing case end face and end face of input shaft rear bearing





Adjusting Shim

CAUTION: Only 1 adjusting shim can be selected.





1. Using depth micrometer and straight edge, measure dimension "O1" between transaxle case end face and mounting face of adjusting shim as shown.





2. Using depth micrometer and straight edge, measure dimension "O2" between clutch housing case end face and end face of input shaft rear bearing as shown.
3. Install selected input shaft rear bearing adjusting shim onto input shaft.