Mainshaft End Play

MAINSHAFT END PLAY





^ When adjusting mainshaft end play, select adjusting shim for mainshaft rear bearing. To select adjusting shim, measure clearance "M" between transaxle case and mainshaft rear bearing.
^ Calculate dimension "P" (thickness of adjusting shim) using the procedure to satisfy specification of end play for mainshaft rear bearing.
End play: 0 - 0.06 mm (0 - 0.0024 inch)
Dimension "P" = "M" - End play
"P": Thickness of adjusting shim
"M": Distance between mainshaft rear bearing and transaxle case





Adjusting Shim

CAUTION: Only 1 adjusting shim can be selected.

1. Install mainshaft assembly to clutch housing.
2. Install snap ring to transaxle case.
3. Install transaxle case to clutch housing, and temporarily assemble them with the bolts. Install temporarily snap ring to mainshaft roller bearing.





4. Install dial gauge to snap ring access hole, and expand snap ring. Lift mainshaft assembly through control assembly installation hole, and push it against transaxle case. This state shall be defined as base. Moving distance of mainshaft assembly, with snap ring fit on main bearing, becomes "M".