Rear Door Window Regulator: Service and Repair

REAR DOOR GLASS AND REGULATOR




Removal And Installation

REMOVAL
1. Remove the rear door finisher. Refer to "Rear Door".




2. Operate the power window switch to raise/lower the door window until the bolts can be seen.
3. Remove the bolts, and place the glass on the inner bottom of the panel.




4. Remove the bolts and the regulator and guide channel from the panel.
5. Disconnect the connector for the regulator assembly.




6. Remove the partition sash from the glass run.
7. Remove the partition sash bolt (lower) and screw (upper) to remove the sash.
8. Remove the glass from the inside of the panel.




9. Remove the partition glass from the panel.

INSTALLATION
Installation is in the reverse order of removal.
Reset Limit Switch after Installation: Programming and Relearning

INSPECTION AFTER REMOVAL

Check the regulator assembly for the following items. If a malfunction is detected, replace or grease it.
- Wire wear
- Regulator deformation
- Grease condition for each sliding part




The arrows in the figure show the application points of the body grease.

FITTING INSPECTION
- Check that the glass is securely fit into the glass run groove.
- Lower the glass slightly [approximately 10 to 20 mm (0.39 to 0.79 in)], and check that the clearance to the sash is parallel. If the clearance between the glass and sash is not parallel, loosen the regulator bolts, guide rail bolts, and glass and carrier plate bolts to correct the glass position.