With Manufacturer's Scan Tool (CONSULT-II)

CONSULT-II Inspection Procedure

"MULTI REMOTE ENT"

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carry out CAN communication.

1. Turn ignition switch OFF.




2. Connect CONSULT-II to the data link connector.
3. Turn ignition switch ON.




4. Touch "START NISSAN BASED VHCL".




5. Touch "BCM".
If "BCM" is not indicated, refer to "CONSULT-II Data Link Connector (DLC) Circuit".




6. Touch "MULTI REMOTE ENT".




7. Select diagnosis mode.
"DATA MONITOR", "ACTIVE TEST" and "WORK SUPPORT" are available.