Rear Door Lock

REAR DOOR LOCK




Component Structure

Removal and Installation

REMOVAL
1. Remove the rear door finisher. Refer to "Removal and Installation".
2. Remove the rear door window and rear door module assembly. Refer to "Removal and Installation".




3. Remove door side grommet, and remove outside handle escutcheon bolt (TORX T30) from grommet hole.

CAUTION: Do not forcibly remove the TORX bolts (T30).




4. While pulling the outside handle, remove outside handle escutcheon.




5. While pulling outside handle, slide toward rear of vehicle to remove outside handle.




6. Remove the front gasket and rear gasket.




7. Remove the TORX bolts (T30), remove the door lock assembly.




8. Remove the TORX bolt (T30), and remove the outside handle bracket.




9. While pulling outside handle, slide toward rear of vehicle to remove outside handle and door lock assembly.
10. Disconnect the door lock actuator connector.




11. Reach to separate outside handle rod connection.

INSTALLATION
Installation is in the reverse order of removal.