With Manufacturer's Scan Tool (CONSULT-II)

CONSULT-II OPERATION

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carry out CAN communication.




1. With the ignition switch OFF, connect CONSULT-II and CONSULT-II CONVERTER to the data link connector, then turn ignition switch ON.




2. Touch "START (NISSAN BASED VHCL)".




3. Touch "BCM".
If "BCM" is not indicated, go to GI-36, "CONSULT-II Data Link Connector (DLC) Circuit". Data Link Connector Schematic




4. Touch "RETAINED PWR".




5. Select diagnosis mode. "DATA MONITOR", "ACTIVE TEST" and "WORK SUPPORT" are available.