Powertrain Management: Technical Service Bulletins

• Customer Interest
  • Emissions - MIL ON/DTC P1402 Set
  • Engine Controls - Engine Idle Speed 25RPM Too High
  • Engine Controls - MIL ON/DTC's P1273/P1283/P1274/P1284
  • Exhaust System - MIL ON/DTC P1273/Rattle on Accel.
  • Electrical - MIL ON/DTC's U1010 or U1000 Stored
  • Fuel System - Ticking Noise From Engine Area
  • A/T - Hard To Move Shifter/Slide Plate Deformed
• By Symptom
  • Customer Interest
    • Emissions - MIL ON/DTC P1402 Set
    • Engine Controls - Engine Idle Speed 25RPM Too High
    • Engine Controls - MIL ON/DTC's P1273/P1283/P1274/P1284
    • Exhaust System - MIL ON/DTC P1273/Rattle on Accel.
    • Electrical - MIL ON/DTC's U1010 or U1000 Stored
    • Fuel System - Ticking Noise From Engine Area
    • A/T - Hard To Move Shifter/Slide Plate Deformed
  • Difficult gear selection
    • A/T - Hard To Move Shifter/Slide Plate Deformed
  • Noise
    • Exhaust System - MIL ON/DTC P1273/Rattle on Accel.
    • Fuel System - Ticking Noise From Engine Area
  • Warping
    • A/T - Hard To Move Shifter/Slide Plate Deformed
• All Technical Service Bulletins
  • Emissions - System Readiness Test (SRT) Drive Patterns
    • Overview
    • Service Procedure
    • System Readiness Test Drive Patterns
  • Computers/Controls - CONSULT III Plus(R) Saved Data List
  • Engine Controls - ECM Replacement Procedures With Consult 3+
    • Overview
    • Service Procedure
  • Computers/Controls - CONSULT(R) Reprogramming Info.
  • Engine Controls - ECM Programming Information
    • Overview
    • Service Procedure
      • Information
      • Setting Up
    • Programming Unexpectedly Terminated
  • Vehicle - Certification Label/VIN Plate Replacement
  • Electrical - MIL ON/DTC P0128 Due To Remote Start Sys.
  • Engine Controls - ECM Programming Interruption Recovery
  • Computers/Control - CAN Code, Diagnostic Tips/Guidelines
  • A/T - 5 Speed A/T DTC Diagnostics
  • Engine Controls - Seized O2 Sensor Removal Procedure
    • Overview
    • Service Procedure
  • Engine Controls - ECM VIN Registration Procedure
  • Engine Controls - CONSULTIII(R) ECM Programming
    • Overview
    • General Procedure
      • Part 1
      • Part 2
  • A/T - CVT/5 Speed Initialization Information
  • Emissions - MIL ON/DTC P1402 Set
  • Electrical - Electronic Component Damage Prevention
  • Engine Controls - Air Flow Meter Service Procedure
  • Engine Controls - MIL ON/Multiple VVT DTC's Set
  • Engine Controls - Engine Idle Speed 25RPM Too High
  • Engine Controls - ECM Replacement Procedures
    • Overview
    • Service Procedure
  • Engine Controls - MIL ON/DTC's P1273/P1283/P1274/P1284
  • A/T - TCM Reprogramming After A/T Replacement
    • Overview
    • ECM & Tcm Reprogramming Procedures
  • Exhaust System - MIL ON/DTC P1273/Rattle on Accel.
  • Electrical - MIL ON/DTC's U1010 or U1000 Stored
  • Fuel System - Cold Weather Engine Starting Tips
  • Fuel System - Ticking Noise From Engine Area
  • A/T - Hard To Move Shifter/Slide Plate Deformed
  • Body Controls - Configurable BCM Replacement Information
  • Keyless Systems - MIL ON, DTC B2190 Set