Vehicle Does Not Creep Forward In "D" Position

Vehicle Does Not Creep Forward In "D" Position

SYMPTOM: Vehicle does not creep forward when selecting "D" position.

DIAGNOSTIC PROCEDURE
1. CHECK A/T FLUID LEVEL
Check the A/T fluid level. Refer to "A/T FLUID CHECK".
OK or NG
OK >>GO TO 2.
NG >>Refill ATF.

2. CHECK CONTROL CABLE AND PNP SWITCH POSITION
Check the control cable and PNP switch position.
^ Refer to "Control Cable Adjustment".
OK or NG
OK >>GO TO 3.
NG >>Adjust control cable and PNP switch position. Refer to "Control Cable Adjustment" or "Park/Neutral Position (PNP) Switch Adjustment".

3. CHECK PRESSURE CONTROL SOLENOID VALVE A CIRCUIT
Perform self-diagnosis.
Do the self-diagnostic results indicate pressure control solenoid valve A?
YES >>Check the malfunctioning system. Refer to "DTC P0745 PRESSURE CONTROL SOLENOID VALVE A (LINE PRESSURE)" P0745.
NO >>GO TO 4.

4. DETECT MALFUNCTIONING ITEM
1. Control valve assembly. Refer to "Control Valve Assembly".
2. Disassemble A/T. Refer to "DISASSEMBLY".
3. Check the following items:
^ Forward and direct clutch assembly. Refer to "DISASSEMBLY".
^ One-way clutch No.2. Refer to "DISASSEMBLY".
^ B5 brake. Refer to "Transaxle Case Cover & B5 Brake".
^ Torque convertor. Refer to "DISASSEMBLY".
OK or NG
OK >>GO TO 5.
NG >>Repair or replace damaged parts.

5. CHECK TCM
1. Check TCM input/output signal. Refer to "TCM Input/Output Signal Reference Values". Pinout Values and Diagnostic Parameters
2. If NG, recheck TCM pin terminals for damage or loose connection with harness connector.
OK or NG
OK >>GO TO 6.
NG >>Repair or replace damaged parts.

6. CHECK SYMPTOM
Check again.
OK or NG
OK >> INSPECTION END
NG >>Repair or replace damaged parts.