ABS and TCS

ACTUATOR AND ELECTRIC UNIT (ASSEMBLY)





Removal and Installation

REMOVAL
1. Disconnect battery cable.
2. Remove windshield wiper and linkage assembly. Refer to "REMOVAL".
3. Drain brake fluid. Refer to "Changing Brake Fluid".
4. Discharge the A/C refrigerant. Refer to "R-134a Service Procedure".
5. Disconnect and remove high-pressure and low-pressure A/C pipes to allow access to ABS actuator and electric unit (control unit). Refer to "Components".
6. Disconnect harness connectors from ABS actuator and electric unit (control unit).
7. Disconnect brake pipes.
8. Remove fasteners for ABS actuator and electric unit (control unit) and remove from vehicle.

INSTALLATION

CAUTION: After installation of ABS actuator and electric unit (control unit), refill brake fluid. Then bleed air from system. Refer to "Bleeding Brake System".

1. Position ABS actuator and electric unit (control unit) in vehicle.
2. Connect brake pipes and fasteners temporarily.
3. Tighten fasteners and brake pipes. Refer to "Hydraulic Circuit" for brake pipe tightening torque.
4. Connect ABS actuator and electric unit (control unit) harness connectors.
5. Install and connect high-pressure and low-pressure A/C pipes. Refer to "Components".
6. Install windshield wiper and linkage assembly. Refer to "INSTALLATION".
7. Reconnect battery cable.
8. Evacuate and recharge the A/C system. Refer to "R-134a Service Procedure".