Transmission Position Sensor/Switch: Adjustments
Park/Neutral Position (PNP) Switch Adjustment1. Remove battery and bracket. Refer to "REMOVAL".
2. Remove cable from range lever.
3. Set range lever in neutral position.
4. Remove range lever and install alignment tool (J-45404).
5. Loosen park/neutral position (PNP) switch bolts.
6. Adjust park/neutral position (PNP) switch so that alignment tool (J-45404) pointer aligns with neutral base line on park/neutral position (PNP) switch body.
7. Tighten park/neutral position (PNP) switch bolts.
8. Reinstall range lever and cable.
9. Adjust control cable. Refer to "Control Cable Adjustment".
10. Reinstall battery and bracket. Refer to "INSTALLATION".
11. Check continuity of park/neutral position (PNP) switch. Refer to "Component Inspection".