Satellite Sensor

SIDE AIR BAG (SATELLITE) SENSOR

Removal and Installation

REMOVAL

CAUTION:
- Before servicing the SRS, turn the ignition switch off, disconnect both battery cables and wait at least 3 minutes.




1. Remove seat belt pre-tensioner. Refer to "Removal and Installation of Front Seat Belt".
2. Remove side air bag (satellite) sensor nuts.
3. Disconnect the side air bag (satellite) sensor harness connector.

CAUTION:
- Do not use old nuts after removal; replace with new nuts.
- Check side air bag (satellite) sensor to ensure it is free of deformities, dents, cracks or rust. If it shows any visible signs of damage, replace it with new one.
- Do not disassemble side air bag (satellite) sensor.
- Replace side air bag (satellite) sensor if it has been dropped or sustained an impact.

INSTALLATION
To install, reverse the removal procedure.

- After the work is completed, perform self-diagnosis to check that no malfunction is detected. Refer to SRS-22, "SRS Operation Check". [1][2]Component Tests and General Diagnostics