Component Inspection

Inspection

SHOCK ABSORBER ASSEMBLY
^ Check for smooth operation through a full stroke of both compression and extension.
^ Check for oil leaks on the welded or gland packing portions.
^ Check the piston rod for cracks, deformation, or other damage and replace if necessary.

SUSPENSION ARM





^ Check the suspension arm for damage, cracks, deformation and replace if necessary.
^ Check the rubber bushing for damage, cracks, deformation and replace if necessary.
^ Check the ball joint. Replace the suspension arm assembly if any of the following conditions exist:
^ Ball stud is worn.
^ Joint is hard to swing.
^ Check if the swinging force "A", turning force "B", or vertical end play "C" is out of specification.

NOTE: Before checking specifications, turn the ball joint at least 10 revolutions so the ball joint is properly broken in.

Swinging force "A" : Refer to "Ball Joint".

Turning force "B" : Refer to "Ball Joint".

Vertical end play "C" : Refer to "Ball Joint".

RADIUS ROD
^ Check the radius rod for any deformation, cracks, or damage and replace if necessary.
^ After installing the radius rod, check the wheel alignment and adjust if necessary.

FRONT LOWER LINK
^ Check the front lower link for any deformation, cracks, or damage and replace if necessary.

UPPER RUBBER SEAT AND BUSHING
^ Check the rubber parts for deterioration, or cracks and replace if necessary.

REAR LOWER LINK AND COIL SPRING
^ Check the rear lower link and coil spring for deformation, cracks, or other damage and replace if necessary.

STABILIZER BAR
^ Check the stabilizer bar and clamps for any deformation, cracks, or damage and replace if necessary.
^ Check the rubber bushings for deterioration, or cracks and replace if necessary.