Input shaft End Play

INPUTSHAFT END PLAY





^ When adjusting the input shaft end play, select the adjusting shim for the input shaft bearing. To select the correct thickness for the adjusting shim, measure the clearance between the transaxle case and input shaft rear bearing.
^ Calculate the dimension "O" (thickness of adjusting shim) using the following steps to adjust the input shaft rear bearing for the specified end play.

CAUTION: Only 1 adjusting shim can be selected.

End play : 0 - 0.06 mm (0 - 0.0024 inch)

Dimension "O" = (Or - On ) - End play

"O" : Thickness of adjusting shim

"O1 : Distance between transaxle case end face and mounting face of adjusting shim

"O2 : Distance between clutch housing case end face and end face of input shaft rear bearing





Adjusting Shims





1. Using a depth micrometer and straight edge, measure the dimension "Or " between the transaxle case end face and mounting face of the adjusting shim as shown.





2. Using a depth micrometer and straight edge, measure the dimension "Of " between the clutch housing case end face and end face of the input shaft rear bearing as shown.
3. Install the selected input shaft rear bearing adjusting shim onto the input shaft.