With Manufacturer's Scan Tool (CONSULT-II)

CONSULT-II BASIC INSPECTION PROCEDURE

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carry out CAN communication.

1. Turn ignition switch OFF.




2. Connect CONSULT-II and CONSULT-II CONVERTER to data link connector.
3. Turn ignition switch ON.




4. Touch "START (NISSAN BASED VHCL)".




5. Touch "BCM".
If "BCM" is not indicated, go to GI-36, "CONSULT-II Data Link Connector (DLC) Circuit". Data Link Connector Schematic




6. Touch "REAR DEFOGGER".




7. Select diagnosis mode.