With Manufacturer's Scan Tool

CONSULT-II INSPECTION PROCEDURE

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carry out CAN communication.




1. Connect CONSULT-II and CONSULT-II CONVERTER to the data link connector.
2. Turn ignition switch ON.




3. Touch "START (NISSAN BASED VHCL)".




4. Touch "BCM".
If "BCM" is not indicated, refer to "CONSULT-II Data Link Connector (DLC) Circuit".




5. Touch "RETAINED PWR".




6. Select diagnosis mode.