With Manufacturer's Scan Tool (CONSULT-II)
CONSULT-II INSPECTION PROCEDUREDOOR LOCK
CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carries out CAN communication.
1. Turn ignition switch OFF.
2. Connect CONSULT-II and CONSULT-II CONVERTER to the data link connector.
3. Turn ignition switch ON.
4. Touch "START (NISSAN BASED VHCL)".
5. Touch "SMART ENTRANCE".
If "SMART ENTRANCE" is not indicated, refer to "CONSULT-II Data Link Connector (DLC) Circuit". Data Link Connector Schematic
6. Touch "DOOR LOCK".
7. Select diagnosis mode. "DATA MONITOR" and "ACTIVE TEST" are available.