Programming and Relearning
Memory Reset AdjustmentIf the battery is disconnected or the sunroof motor harness connector is disconnected, the sunroof motor memory must be reset. To reset the sunroof motor memory from any sunroof position (full open, partially open, closed, partially vented, and vented), push and hold the sunroof button in the forward position until the sunroof vents in the full up position. This resets the sunroof motor memory and now the sunroof will operate correctly.
Install motor and limit SW assembly and sunroof rail assembly in the following sequence:
1. Arrange equal lengths of link and wire assemblies on both sides of the sunroof opening.
2. Connect the sunroof connector to the sunroof switch and positive (+) power supply.
3. Set the lid assembly to the fully closed position (A) by operating the sunroof switch.
4. Fit the outer side of the lid assembly to the surface of the roof outer body panel.
5. Remove the motor and keep the DOWN/OPEN switch depressed until the motor pinion gear reaches the end of its rotating range.
6. Install the motor.
7. Check that the motor drive gear fits properly in wires.
8. Press the UP/CLOSE switch to check the lid assembly for normal tilting.
9. Check the sunroof lid assembly for normal operations (tilt up, tilt down, open and close).