Active Test

ACTIVE TEST PROCEDURE
^ When conducting Active test, vehicle must be stationary.
^ When ABS warning lamp stays on, never conduct Active test.

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carries out CAN communication.





1. Turn ignition switch OFF.
2. Connect CONSULT-II and CONSULT-II CONVERTER to the data link connector.
3. Start engine.
4. Touch START (NISSAN BASED VHCL) on CONSULT-II screen.





5. Touch ABS. If ABS is not indicated, go to GI-38, CONSULT-II Data Link Connector (DLC) Circuit. CONSULT-II Checking System





6. Touch ACTIVE TEST.





7. Select active test item by touching screen.





8. Touch START.
9. Carry out the active test by touching screen key.

ACTIVE TEST MODE





NOTE: Active test will automatically stop ten seconds after the test starts. (TEST IS STOPPED monitor shows ON.)