Operation CHARM: Car repair manuals for everyone.

Displaying & Reading Trouble Codes

Meter/Gauge Operation and Odo/Trip Meter Segment Check in Diagnosis Mode

HOW TO ALTERNATE DIAGNOSIS MODE




1. Turn ignition switch to ON and change odo/trip meter to "TRIP A" or "TRIP B".
2. Turn ignition switch to OFF.
3. Turn ignition switch to ON when pushing odo/trip meter switch.
4. Release odo/trip meter switch 1 second after ignition switch is turned ON.
5. Push odo/trip meter switch three times within 7 seconds.
6. All odo/trip meter segments should be turned on.

NOTE: If some segments are not turned on, combination meter should be replaced.
At this point, the unified meter control unit is turned to diagnosis mode.




7. Push odo/trip meter switch. Indication of each meter/gauge should be as shown in figure while pushing odo/trip meter switch.

NOTE: It takes a few seconds for indication of fuel gauge and water temperature gauge to become stable.

8. Turn ignition switch to OFF or start engine to cancel diagnosis mode.