Draining & Filling Fluid
ReplacementDRAINING
1. Start the engine and let it run to warm up the transaxle.
2. Stop the engine. Remove drain plug and drain oil.
3. Set a gasket on the drain plug and install it on the transaxle.
Drain plug: 10 - 19 Nm (1.0 - 2.0 kg-m, 87 - 173 inch lbs.)
CAUTION: Do not reuse gasket.
FILLING
1. Remove filler plug. Fill with new oil until oil level reaches the specified limit near filler plug mounting hole as shown.
Oil grade: API GL-4, Viscosity SAE 75W-85
Capacity (approximately): 3.0 L (3 1/8 US qt, 2 5/8 Imp qt)
2. After refilling oil, check oil level as shown.
3. Install the filler plug in the transaxle case using a new gasket.
Filler plug: 10 - 19 Nm (1.0 - 2.0 kg-m, 87 - 173 inch lbs.)
CAUTION: Do not reuse gasket.