Cruise Test - Part 2
Cruise Test - Part 21. CHECK STARTING GEAR (D1) POSITION
1. Confirm overdrive control switch is in ON position.
2. Confirm A/T selector lever is in D position.
3. Accelerate vehicle by half throttle again.
4. Does vehicle start from D1?
Read gear position.
Yes or No
Yes >> GO TO 2.
No >> Go to AT-244, 16. Vehicle Does Not Start From D1. Vehicle Does Not Start From D1
Continue ROAD TEST.
2. CHECK SHIFT UP AND SHIFT DOWN (D3 TO D4 TO D2)
1. Accelerate vehicle to 80 km/h (50 MPH) as shown in illustration.
2. Release accelerator pedal and then quickly depress it fully.
3. Does A/T shift from D4 to D2 as soon as accelerator pedal is depressed fully?
Read gear position and throttle position.
Yes or No
Yes >> GO TO 3.
No >> Go to AT-233, 9. A/T Does Not Shift: D1 -> D2 Or Does Not Kickdown: D4 -> D2. A/T Does Not Shift: D1 -> D2 or Does Not Kickdown: D4 -> D2
Continue ROAD TEST.
3. CHECK SHIFT UP (D2 TO D3)
Does A/T shift from D2 to D3 at the specified speed?
Read gear position, throttle position and vehicle speed.
Specified speed when shifting from D2 to D3: Refer to Shift Schedule.
Yes or No
Yes >> GO TO 4.
No >> Go to AT-235, 10. A/T Does Not Shift: D2 -> D3. A/T Does Not Shift: D2 -> D3
Continue ROAD TEST.
4. CHECK SHIFT UP (D3 TO D4) AND ENGINE BRAKE
Release accelerator pedal after shifting from D2 to D3.
Does A/T shift from NG, to D4 and does vehicle decelerate engine brake?
Read gear position, throttle position and vehicle speed.
Yes or No
Yes >>
1. Stop vehicle.
2. Go to AT-82, Cruise Test-Part 3.
No >> Go to AT-237, 11. A/T Does Not Shift: D3 -> D4. A/T Does Not Shift: D3 -> D4
Continue ROAD TEST.