Control Unit (RAM), Control Unit (ROM)
DTC CONTROL UNIT (RAM), CONTROL UNIT (ROM)Description
The TCM. consists of a microcomputer and connectors for signal input and output and for power supply. The unit controls the A/T.
ON BOARD DIAGNOSIS LOGIC
DIAGNOSTIC TROUBLE CODE (DTC) CONFIRMATION PROCEDURE
NOTE: If DIAGNOSTIC TROUBLE CODE CONFIRMATION PROCEDURE has been previously conducted, always turn ignition switch OFF and wait at least 5 seconds before conducting the next test.
With CONSULT-II
1. Turn ignition switch ON and select DATA MONITOR mode for A/T with CONSULT-II.
2. Start engine.
3. Run engine for at least 2 seconds at idle speed.
Diagnostic Procedure
1. INSPECTION START (WITH CONSULT-II)
With CONSULT-II
1. Turn ignition switch ON and select SELF DIAGNOSIS mode for A/T with CONSULT-II.
2. Touch ERASE.
>> GO TO 2.
2. CHECK DTC
Perform AT-211, DIAGNOSTIC TROUBLE CODE (DTC) CONFIRMATION PROCEDURE.
>> GO TO 3.
3. CHECK DTC AGAIN
Is the CONTROL UNIT (RAM) or CONTROL UNIT (ROM) displayed again?
Yes or No
Yes >> Replace TCM.
No >> INSPECTION END