Sunroof / Moonroof: Adjustments

SUNROOF




ADJUSTMENT
If any gap or height difference between glass lid and roof is found, check glass lid fit and adjust as follows:

Gap Adjustment
1. Open the shade assembly.
2. Tilt the glass lid up then remove the side trim.
3. Loosen the glass lid securing bolts (3 each on left and right sides), then tilt the glass lid down.
4. Adjust the glass lid from outside of vehicle so it resembles "A-A" as shown in the figure.
5. Tilt the glass lid up and down until it is adjusted to "B-B" as shown in the figure.
6. After adjusting the glass lid, tilt the glass lid up and tighten the bolts.
7. Tilt the glass lid up and down several times to check that it moves smoothly.

Height Difference Adjustment
1. Tilt the glass lid up and down.
2. Check the height difference between the roof panel and the glass lid to see if it is as "A-A" as shown in the figure.
3. If necessary, adjust it by using one of following procedures.
- Adjust by adding or removing adjustment shim(s) between the glass lid and link assembly.
- If the glass lid protrudes above the roof panel, add shim(s) or plain washer(s) at the sunroof mounting bracket or stud bolt locations to adjust sunroof installation as required.