Valve Clearance: Adjustments

VALVE ADJUSTMENT
^ Perform adjustment depending on selected head thickness of valve lifter.
^ The specified valve lifter thickness is the dimension at normal temperatures. Ignore dimensional differences caused by temperature. Use the specifications for hot engine condition to adjust.

1. Remove camshaft.
2. Remove the valve lifters at the locations that are outside the standard.





3. Measure the center thickness of the removed valve lifters with a micrometer.
4. Use the equation below to calculate valve lifter thickness for replacement.
^ Valve lifter thickness calculation.
t = t1 + (C1 - C2)
t = Thickness of replacement valve lifter.
t1 = Thickness of removed valve lifter.
C1 = Measured valve clearance.
C2 = Standard valve clearance.





^ Thickness of a new valve lifter can be identified by stamp marks on the reverse side (inside the cylinder). Stamp mark 696 indicates a thickness of 6.96 mm (0.2740 inch) Available thickness of valve lifter, refer to Available Valve Lifter.




Available Shims

5. Install the selected valve lifter.
6. Install camshaft. Refer to INSTALLATION.
7. Manually turn crankshaft pulley a few turns.
8. Check that valve clearances for cold engine are within specifications. refer to Valve Clearance.
9. After completing the repair, check valve clearances again with the specifications for warmed engine. Use a feeler gauge to measure the clearance between the valve and camshaft. Make sure the values are within specifications. Refer to Valve Clearance.