CONSULT-II Inspection Procedure

INSPECTION PROCEDURE
1. Turn ignition switch OFF.




2. Connect CONSULT-II and CONSULT-II CONVERTER to data link connector, which is located under LH dash panel.
3. Turn ignition switch ON.




4. Touch "START" (NISSAN BASED VHCL).




5. Touch "ENGINE".
If "ENGINE" is not indicated, go to GI-38, "CONSULT-II Data Link Connector (DLC) Circuit". CONSULT-II Checking System




6. Perform each diagnostic test mode according to each service procedure.

For further information, see the CONSULT-II Operation Manual.