Vehicle Damage Warnings

CAUTION:
- Before removing the fuel line parts, use the following procedures:
- Store the drained fuel in an explosion-proof container and put the lid on securely.
- Release the fuel pressure from the fuel system. Refer to "FUEL PRESSURE RELEASE" (QG18DE), "FUEL PRESSURE RELEASE" (QR25DE).
- Disconnect the battery ground cable.

- Always replace the O-ring seals with new ones.
- Do not kink or twist any of the hoses and tubes during removal and installation.
- Do not over tighten the hose clamps to avoid damaging the hoses.
- After installation, run the engine and check for fuel leaks at the connections.
- Use only a genuine NISSAN fuel filler cap as a replacement. If an incorrect fuel filler cap is used, the MIL may come on.
- For inspection and installation of EVAP system parts, refer to "EVAPORATIVE EMISSION SYSTEM" (QG18DE), "EVAPORATIVE EMISSION SYSTEM" (QR25DE).
- For inspection and installation of ORVR system parts, refer to "ON BOARD REFUELING VAPOR RECOVERY (ORVR)" (QG18DE), "ON BOARD REFUELING VAPOR RECOVERY (ORVR)" (QR25DE).