Control Unit (RAM), Control Unit (ROM)

DTC CONTROL UNIT (RAM), CONTROL UNIT (ROM)

Description





The TCM consists of a microcomputer and connectors for signal input and output and for power supply. The unit controls the A/T.

On Board Diagnosis Logic
Diagnostic trouble code CONTROL UNIT (RAM), CONTROL UNIT (ROM) with CONSULT-II is detected when TCM memory (RAM) or (ROM).

Possible Cause
Check TCM.

Diagnostic Trouble Code (DTC) Confirmation Procedure

NOTE: If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

WITH CONSULT-II





1. Turn ignition switch ON and select DATA MONITOR mode for A/T with CONSULT-II.
2. Start engine.





3. Run engine for at least 2 seconds at idle speed.

Diagnostic Procedure
1. INSPECTION START

With CONSULT-II
1. Turn ignition switch ON and select SELF DIAGNOSIS mode for A/T with CONSULT-II.
2. Touch ERASE.
3. Perform AT-589, Diagnostic Trouble Code (DTC) Confirmation Procedure.
4. Is the CONTROL UNIT (RAM) or CONTROL UNIT (ROM) displayed again?
Yes or No
Yes >> Replace TCM
No >> INSPECTION END