Vehicle Does Not Start From D2

16. Vehicle Does Not Start From D2

SYMPTOM: Vehicle does not start from D2 on Cruise test-Part 2.

1. CHECK SELF-DIAGNOSTIC RESULTS





Does self-diagnosis show damage to vehicle speed sensor A/T (revolution sensor), shift solenoid valve A, B or vehicle speed sensor MTR after cruise test?
Yes or No
Yes >> Check damaged circuit. Refer to DTC P0720 VEHICLE SPEED SENSOR-A/T (REVOLUTION SENSOR], DTC P0750 SHIFT SOLENOID VALVE A, DTC P0755 SHIFT SOLENOID VALVE B or DTC VEHICLE SPEED SENSOR MTR.
No >> GO TO 2.

2. CHECK SYMPTOM
Check again.
OK or NG
OK >> Go to AT-609, 8. Vehicle Cannot Be Started From D1. Vehicle Cannot Be Started From D1
NG >> GO TO 3.

3. CHECK TCM INSPECTION
1. Perform TCM input/output signal inspection. Pinout Values and Diagnostic Parameters
2. If NG, recheck TCM pin terminals for damage or loose connection with harness connector.
OK or NG
OK >> INSPECTION END
NG >> Repair or replace damaged parts.