With Manufacturer's Scan Tool

CONSULT-II INSPECTION PROCEDURE

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carry out CAN communication.




1. Turn the ignition switch "OFF".
2. Connect "CONSULT-II" to the data link connector.




3. Turn ignition switch "ON".
4. Touch "START (NISSAN BASED VHCL)".




5. Touch "SMART ENTRANCE".




6. Perform each diagnostic item according to "DIAGNOSTIC ITEMS APPLICATION". Refer to BCS-5, "DIAGNOSTIC ITEMS APPLICATION". Scan Tool Testing and Procedures