Final Drive
FINAL DRIVEDisassembly and Assembly
DISASSEMBLY
1. Remove the mounting bolts. Then, separate the final gear from the differential case.
2. Remove the speedometer drive gear.
3. Using a puller and Tool (drift), remove the differential side bearing (clutch housing side) as shown.
4. Using a puller and Tool (drift), remove the differential side bearing (transaxle case side) as shown.
INSPECTION AFTER DISASSEMBLY
Bearing
Check for bearing damage and rough rotation as shown. If necessary, replace with a new one.
CAUTION: When replacing the tapered roller bearing, replace the outer and inner races as a set.
ASSEMBLY
1. Using Tool (drift), install the differential side bearing (transaxle case side) as shown.
2. Align and install the speedometer drive gear onto the differential case as shown.
3. Using Tool (drift), install the differential side bearing (clutch housing side) as shown.
4. Install the final gear into the differential case, and tighten the final gear bolts to specification.
Final gear bolts: Refer to FINAL DRIVE COMPONENTS.