Control Linkage

CONTROL LINKAGE

Removal and Installation
TRANSAXLE GEAR CONTROL





Refer to the illustration for the removal and installation procedure.

STRIKING ROD OIL SEAL





1. Remove the transaxle control rod from yoke.
2. Remove the retaining pin from the yoke using Tool as shown.

CAUTION: Be careful not to damage the boot.





3. Remove the boot.
4. Remove the striking rod oil seal with a suitable tool (drift).





5. Install the striking rod oil seal using Tool as shown.
^ Apply multi-purpose grease to the seal lip of the oil seal before installing.
6. Install the boot.
7. Install the yoke and retaining pin.
8. Connect the transaxle control rod to the yoke.