Removal and Installation of Control Device and Cable

CONTROL LINKAGE

Part 1:

Part 2:

Removal and Installation of Control Device and Cable

CAUTION: Note that the select side lock plate for securing the control cable is different from the one on the shift side.

After assembly, make sure selector lever automatically returns to Neutral when it is moved to 1st, 2nd, or Reverse.

Cable Adjustment

NOTE: After installation of the select cable, the cable must be adjusted for proper operation. This adjustment is performed before installing the interior console and shift boot.





1. Slide clip B from under clip A as shown.
2. Shift the control lever to the neutral position.

CAUTION: Do not move the control lever when adjusting the cables.





3. Push clip A into the cable end case until it snaps into place as shown.





4. Slide clip B back over clip A until it snaps into place and holds clip A in place as shown.