Passenger Side

PASSENGER SIDE

PASSENGER SIDE : Description
Transmits door lock/unlock operation to BCM.

PASSENGER SIDE : Component Function Check

Step 1:

PASSENGER SIDE : Diagnosis Procedure (With LH and RH Anti-Pinch)

Step 1:

Step 1 (Continued)-3:

Step 3 (Continued)-4:

PASSENGER SIDE : Diagnosis Procedure (With LH Anti-Pinch Only)

Step 1-3:

Step 3 (Continued)-5:

PASSENGER SIDE : Special Repair Requirement

NOTE: This procedure is applicable to vehicles equipped with front LH and RH anti-pinch windows only.

INITIALIZATION PROCEDURE
1. Disconnect battery minus terminal or power window main switch connector. Reconnect it after a minute or more.
2. Turn ignition switch ON.
3. Operate power window switch to fully open the window. (This operation is unnecessary if the window is already fully open)
4. Continue pulling the power window switch UP (AUTO-UP operation). Even after glass stops at fully closed position, keep pulling the switch for 3 seconds or more.
5. Inspect anti-pinch function.

CHECK ANTI-PINCH FUNCTION
1. Fully open the door window.
2. Place a piece of wood near fully closed position.
3. Close door glass completely with AUTO-UP.
- Check that glass lowers for approximately 150 mm or 2 seconds without pinching piece of wood and stops.
- Check that glass does not rise when operating the power window main switch while lowering.

CAUTION:
- Do not check with hands and other part of body because they may be pinched. Do not get pinched.
- Check that AUTO-UP operates before inspection when system initialization is performed.
- It may switch to fail-safe mode if open/close operation is performed continuously. Perform initial setting in that situation. Refer to DLK-179, "Fail Safe" Fail Safe
- Perform initial setting when auto-up operation or anti-pinch function does not operate normally.
- Finish initial setting. Otherwise, next operation cannot be done.

1. Auto-up operation
2. Anti-pinch function
3. Retained power operation when ignition switch is OFF.