Overhaul

DISASSEMBLY AND ASSEMBLY

DOOR MIRROR

Exploded View

Exploded View MIR-17:

Disassembly
1. Turn the mirror glass surface upward.




2. Apply a protective tape A to mirror housing. Insert a suitable tool B into the concave gap between the mirror holder (1) and mirror motor (2) Push up tabs (3) (two locations) on the mirror holder to disengage the lower part of mirror holder, and remove the mirror body assembly.

NOTE: When pushing up tabs (3), do not forcefully push up only one concave position but try to push up two concave positions.




3. Remove the mirror body (1) from the mirror housing assembly (2).
4. Remove two terminals of mirror heater connector.




5. Remove the screws and power unit from the housing.

Assembly
1. Install the mirror motor.
2. Install the mirror cover.
3. Place mirror holder bracket and mirror body assembly (actuator) in a horizontal position.
4. Connect two terminals of heater installed mirror.




5. Engage the upper tabs on the mirror body (1) onto the mirror motor (2) Then press the lower side of mirror face until a click sound is heard to engage the lower tabs.

NOTE: After installation, visually make sure lower two tabs are securely engaged from the bottom of mirror face. Make sure to insert the harness terminals into the correct connector. Do not confuse the locations.