Overhaul

DISASSEMBLY AND ASSEMBLY

FRONT SEAT

DRIVER SIDE

DRIVER SIDE : Exploded View

SE-22 Exploded View (Part 1):

SE-22 Exploded View (Part 2):

PASSENGER SIDE

PASSENGER SIDE : Exploded View

SE-24 Exploded View (Part 1):

SE-24 Exploded View (Part 2):

PASSENGER SIDE : Disassembly

Disassembly and Assembly

Disassembly

CAUTION:
- During installation, the wire harness clips must be reinstalled in the holes they were originally in. Do not add additional clips.

NOTE: If the vehicle has been involved in a collision, the seat must be inspected for damage. Refer to SRS-17, "For Frontal Collision". Service and Repair

1. Remove the front seat assembly.
2. Remove the front seat finisher and seat outer finisher.




3. Remove two bolts and two rear clips retaining the seat cushion, remove seat cushion and trim.
4. Remove the retainer on the seat cushion frame, then remove the harness connector for the seat heater.
5. After removing the seat cushion trim and pad, remove the hog rings to separate the trim from the pad and seat cushion heater unit.

Assembly
Assembly is in the reverse order of disassembly.