Front Seat

FRONT SEAT

Exploded View

DRIVER'S SEAT

SE-17 Exploded View (Part 1):

SE-17 Exploded View (Part 2):

PASSENGER'S SEAT

SE-18 Exploded View (Part 1):

SE-18 Exploded View (Part 2):

Removal and Installation

REMOVAL

CAUTION:
- Before removing the front seat, turn the ignition switch off, disconnect both battery cables and wait and least 3 minutes.
- When checking the power seat circuit for continuity using a circuit tester, do not confuse its connector with the side air bag module connector. Such an error may cause the air bag to deploy.
- Do not drop, tilt, or bump the side air bag module while installing the seat. Always handle it with care.
- After front side air bag module inflates, front seatback assembly must be replaced.
- Always replace passenger seat cushion as an assembly if equipped with Occupant Classification System.

NOTE: When removing or installing the seat trim, handle it carefully to keep dirt out and avoid damage.

1. Slide the seat until the four body mounting bolts are visible and a tool can be inserted.
2. Disconnect both battery cables and wait at least 3 minutes.
3. Remove the harness connector for the side air bag module.
4. Remove the four body mounting bolts.
5. Remove the power seat harness connector and vehicle harness fixing clip from the vehicle.

NOTE: When removing and installing, use shop cloths to protect the parts from damage where they may interfere with other parts.

INSTALLATION
Installation is in the reverse order of removal.







NOTE: When installing the front seats tighten the drivers seat mounting bolts in the the following order.
1. Front inner.
2. Front outer.
3. Rear inner.
4. Rear outer.





When installing the front seats tighten the passenger seat mounting bolts in the the following order
1. Front inner.
2. Front outer.
3. Rear inner.
4. Rear outer.