Service Procedure
SERVICE PROCEDURECheck CONSULT-III (C-III) Software Version
NOTE:
C-III software version must be 08.14.01.00.00 or later to perform this procedure.
1. Turn ON the Toughbook(R) PC.
2. Start CONSULT-III (C-III).
3. Select OK (see Figure A).
4. Select Sub-Mode.
5. Select Version-Display.
6. Make sure the C-III software version is Ver.08.14.01.00.00 or later (see Figure C).
^ If the software version is not Ver.08.14.01.00.00 or later, update the C-III software before doing this procedure.
BCM TPMS Configuration
1. Connect the Vehicle Interface (VI) to the vehicle
2. Make sure the Toughbook(R) PC battery is charged, or connect the AC Adapter.
3. Turn the ignition ON (engine OFF).
4. Turn ON the Toughbook(R) PC.
5. Start CONSULT-III (C-III) or select the Home icon.
6. Wait for the "Detecting VI/MI in progress" message to clear.
7. Select the detected VI from the list. (See Figure 1.)
8. Select Connect.
9. Wait for the "Checking the firmware version" message to clear.
10. Select Altima and the the applicable model year from the list. (See example in Figure 2.)
11. Select Select.
12. Make sure the correct vehicle is displayed. (See Figure 3.)
13. Select Confirm.
14. Wait for the System Call and CAN Diagnosis to complete.
NOTE:
When CAN Diagnosis reaches more than 51 % the icons will light. At that point you can continue with the procedure.
15. Select the "Repair" icon.
16. Select the "Electronical Repair" icon.
17. Select BCM.
18. In the "Select Sub System" pop-up window use the scroll bar to find and select BCM. (See Figure 7.)
19. Select OK.
20. Select OK.
21. Select the "Configuration " con.
22. Select OK.
23. Select WRITE CONFIGURATION - Manual setting. (See Figure 11.)
24. Select Next.
NOTE:
It is recommended that you write down or print the manual setting items and values (see Figure 12). Although it is not expected, you will need them if the BCM is replaced.
25. Make sure the Tire Pressure Value matches the label on the drivers door jam (see Figure 12).
26. Select Setting Change.
27. Select OK.
28. Select Auto setting item.
29. Use the scroll bar to find the TPMS setting and make sure it is set to "With" (see Figure 15).
30. Select OK.
31. Close C-III.
32. Turn the ignition OFF.
33. Disconnect the VI from the vehicle.
34. Check the tire pressure in all 4 tires; adjust as need.
^ Refer to the label on the driver's door jam for tire pressure specification.
NOTE:
Tire pressure should be checked often, especially after seasonal temperature changes.
35. Turn the ignition ON and make sure the low tire pressure warning light comes on for about 1 second and then goes out.