Engine Control Module

TERMINAL LAYOUT






PHYSICAL VALUES

NOTE:
- ECM is located in the engine room left side near inverter with converter assembly.
- Specification data are reference values and are measured between each terminal and ground.
- Pulse signal is measured by CONSULT-III.
- If necessary, activate "INSPECTION MODE 1" (HBC-97).

CAUTION: Do not use ECM ground terminals when measuring input/output voltage. Doing so may result in damage to the ECMs transistor. Use a ground other than ECM terminals, such as the ground.

Terminals And Reference Values (Part 1):

Terminals And Reference Values (Part 2):

Terminals And Reference Values (Part 3):

Terminals And Reference Values (Part 4):

Terminals And Reference Values (Part 5):

Terminals And Reference Values (Part 6):

Terminals And Reference Values (Part 7):

Terminals And Reference Values (Part 8):