Accelerator Control System

ON-VEHICLE REPAIR

ACCELERATOR CONTROL SYSTEM

Exploded View

Exploded View ACC-3:

Removal and Installation

REMOVAL
1. Disconnect the accelerator position sensor electrical connector.
2. Remove the accelerator pedal nuts.
3. Remove the accelerator pedal assembly.
- For electrical inspection of the accelerator pedal position sensor. Refer to HBC-491, "Description". P2126

CAUTION:
- Do not disassemble the pedal assembly.
- Avoid impact from dropping during handling.
- Keep the pedal assembly away from water.

INSTALLATION
Installation is in the reverse order of removal.
- Check the accelerator pedal for smooth operation. There should be no binding or sticking when applying or releasing the accelerator pedal.




- Check that the accelerator pedal moves through the full specified distance of pedal travel.

Pedal travel "A": 48.5 - 53.5 mm (1.91 - 2.11 in)

CAUTION: When the harness connector of the accelerator pedal position sensor is disconnected, perform the "Accelerator pedal released position learning". Refer to HBC-12, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT: Special Repair Requirement". Additional Service When Replacing Control Unit