Transmission Position Sensor/Switch: Service and Repair
PARK/NEUTRAL POSITION (PNP) SWITCHTM-31 Exploded View:
Removal and Installation
CAUTION: When replacing the PNP switch, replace the manual lever with new one or transfer the manual lever (1) from the old PNP switch to the new PNP switch. The manual lever must have a rectangular hole as shown for proper operation of the transaxle.
REMOVAL
1. Remove the nut and shift cable from the manual lever.
2. Disconnect the connector from the PNP switch.
3. Remove the PNP switch bolts (A) and the PNP switch.
INSTALLATION
Installation is in the reverse order of removal.
NOTE:
^ Align PNP switch position when installing.
^ After installation of PNP switch, check the continuity of PNP switch.
^ After installation is complete, adjust and check transaxle position. Refer to TM-28, "Inspection and Adjustment". Adjustments