Transmission Position Sensor/Switch: Service and Repair
Park/Neutral Position (PNP) SwitchAT-220 Components:
REMOVAL AND INSTALLATION
Removal
1. Disconnect the battery negative terminal.
2. Remove air duct (inlet).
3. Remove control cable (1) from manual shaft.
4. Disconnect PNP switch harness connector (2).
5. Remove PNP switch bolts.
6. Set manual shaft in "P" position.
7. Remove PNP switch from A/T.
Installation
Installation is in the reverse order of removal.
NOTE:
^ Align PNP switch position when installing.
^ After installation is completed, adjust and check the PNP switch and A/T position. Refer to "PARK/NEUTRAL POSITION (PNP) SWITCH ADJUSTMENT", AT-207, "Adjustment of A/T Position" and AT-207, "Checking of A/T Position".
Adjustments
Procedures
^ After installation is completed, check continuity of PNP switch. Refer to AT-171, "Component Inspection". PNP, OD Switch and Closed Throttle, Wide Open Throttle Position Signal Circuit
PARK/NEUTRAL POSITION (PNP) SWITCH ADJUSTMENT
1. Remove air duct (inlet).
2. Set selector lever and manual shaft (1) in "N" position.
3. Remove control cable from manual shaft (1).
4. Loosen PNP switch bolts.
<---: Bolt (3)
5. Insert the pin (3) [4 mm (0.16 in) dia.] straight into manual shaft (1) adjustment hole.
6. Rotate PNP switch (2) until the pin (3) can also be inserted straight into hole in PNP switch (2).
7. Tighten PNP switch bolts to the specified torque. Refer to "COMPONENTS".
8. Remove the pin (3) from adjustment hole after adjusting PNP switch (2).
9. Install the control cable.
10. Adjust and check A/T position. Refer to AT-207, "Adjustment of A/T Position" and AT-207, "Checking of A/T Position".
Adjustments
Procedures
11. Check continuity of PNP switch (2). Refer to AT-171, "Component Inspection". PNP, OD Switch and Closed Throttle, Wide Open Throttle Position Signal Circuit
12. Install the air duct (inlet).