System Specifications

EM-37 Component:

Timing Chain Tensioner

Crankshaft Pulley
Tighten crankshaft pulley bolt in three steps.
Step 1 68.6 Nm (7.0 kg-m, 51 ft-lb)
Step 2 0 Nm (0 kg-m, 0 ft-lb)
Step 3 29.4 Nm (3.0 kg-m, 22 ft-lb)





Put a paint mark (B) on crankshaft pulley (2), matching with any one of six easy to recognize angle marks (A) on crankshaft pulley bolt flange (1).
Turn another 60 degrees clockwise (angle tightening) using Tool.
Check the tightening angle with movement of one angle mark.
Tool number KV10112100 (BT-8653-A)
Make sure that crankshaft rotates clockwise smoothly.

Timing Cover





Install front cover, and tighten bolts in numerical order as shown.

CAUTION:
Attaching should be done within 5 minutes after liquid gasket application.

NOTE:
Installation position of bolts is as shown.
M6 bolts No. 1
M10 bolts No. 6, 7, 10, 11, 14
M12 bolts No. 2, 4, 8, 12
M8 bolts Except the above

Tighten all bolts are in two stages to specified torque in numerical order as shown.

CAUTION:
Be sure to wipe off any excessive liquid gasket leaking.