Component Tests and General Diagnostics
On-Vehicle Inspection and ServiceCHECKING CONDITION OF INSTALLATION
^ Check installation conditions of steering gear assembly, front suspension assembly, axle and steering column assembly.
^ Check if movement exists when steering wheel is moved up and down, to the left and right and to the axial direction.
Steering wheel axial end play: 0 mm (0 in)
^ Check steering gear assembly mounting bolts and nuts for looseness.
CHECKING STEERING WHEEL PLAY
^ Turn steering wheel so that front wheels come to the straight-ahead position. Start engine and lightly turn steering wheel to the left and right until front wheels start to move. Measure steering wheel movement on the outer circumference.
Steering wheel play: 0 - 35 mm (0 - 1.38 in)
^ When the measurement value is outside the standard value, check backlash for each joint of steering column assembly and installation condition of steering gear assembly.
CHECKING NEUTRAL POSITION STEERING WHEEL
^ Make sure that steering gear assembly, steering column assembly and steering wheel are installed in the correct position.
^ Perform neutral position inspection after wheel alignment. Refer to RSU-2, "Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"". Rear Suspension
^ Set vehicle to the straight-ahead position and confirm steering wheel is in the neutral position.
^ Loosen outer socket lock nut and turn inner socket to left and right equally to make fine adjustments if steering wheel is not in the neutral position.
CHECKING STEERING WHEEL TURNING FORCE
1. Park vehicle on a level and dry surface, set parking brake.
2. Start engine.
3. Check steering wheel turning force when steering wheel has been turned 360° from neutral position using suitable tool as shown.
Steering wheel turning force: Less than 36 N (3.7 kg-f, 8.2 lb-f)
4. If steering wheel turning force is out of the specification, refer to STC-6, "How to Perform Trouble Diagnosis". How to Perform Trouble Diagnosis
CHECKING FRONT WHEEL TURNING ANGLE
^ Check front wheel turning angle after toe-in inspection. Place front wheels on turning radius gauges and rear wheels on stands. Check the maximum inner and outer wheel turning angles for LH and RH road wheels.
^ With the engine at idle, turn steering wheel from full left stop to full right stop and measure the turning angles.
^ Measure rack stroke if angles are outside the specified value.
Rack stroke "L": 65.0 mm (2.559 in)
^ Disassemble steering gear assembly to check the cause that rack stroke is outside of the standard.
^ Steering angles are not adjustable. Check steering gear assembly, steering column assembly and front suspension components for wear or damage if any of the turning angles are different from the specified value. Replace any of them, if any non-standard condition exists.