Assembly (1)

Assembly (1)








1. Drive each differential side oil seal evenly using a drift (SST and commercial service tool) so that differential side oil seal protrudes by the dimension "C" or "D" respectively.
(1): LH differential side oil seal
(2): RH differential side oil seal
(A): Transaxle case side
(B): Converter housing side

NOTE: Differential side oil seal pulling direction is used as the reference.





2. Install O-ring on governor cap.

CAUTION:
^ Do not reuse O-ring.
^ Apply ATF to O-ring.

3. Install governor cap in transaxle case.
4. Install snap ring in transaxle case.





5. Install parking actuator support (1) on transaxle case.
(A): Inside
(B): Outside

CAUTION: Be careful with the direction of parking actuator support (1).

6. Tighten parking actuator support fitting bolts to the specified torque. Refer to AT-230, "Component". Component





7. Install parking pawl (2) on transaxle case, and fix it with parking shaft (1).





8. Install return spring (2) on parking shaft (3) and parking pawl (1) using a flat-bladed screwdriver.